Samsung SyncMaster 400CX-2 User Manual page 27

When done, mount the wall bracket on the wall.
There are two hinges(left and right). Use the correct one.
A - Captive Screw
B - Wall Bracket
C - Hinge (Left)
D - Hinge (Right)
2. Before drilling into the wall, check if the length between the two locking holes at
the back of the product is correct.
If the length is too short or long, loosen all or some of the 4screws on the wall
bracket to adjust the length.
A - Length between the two locking holes
3. Check the installation diagram and mark the drill points on the wall. Use the 5.0 mm
bit to drill holes deeper than 35 mm. Fix each anchor in the corresponding hole.
Match each of the brackets and hinge holes to the corresponding anchor holes and
insert and tighten the 11 screws A.
Introduction
26