Appendix 2. Rf Exposure Statement - LG -RD5130 User Manual

Table of Contents

Advertisement

Connect the red wire to the car battery positive terminal and the black wire to the car ground.
Connect the green wire to the car ignition sensor terminal. ( In order to operate HFK please make
sure to connect green wire to ignition sensor terminal.) Connect the kit' s power cable connector to
the interface box power receptacle.
2.5.2 Antenna Cable Connection
Connect the antenna coupler cable connector from the cradle to the external antenna connector.
( Antenna is not included.)

Appendix 2. RF Exposure Statement

WARNING!
Read this information before operating the phone.
In August 1996, the Federal Communications (FCC) of the United States, with its action in Report
and Order FCC 96-326, adopted an updated safety standard for human exposure to radio
frequency(RF) electromagnetic energy emitted by FCC regulated transmitters. Those guidelines
are consistent with the safety standard previously set by both U.S. and international standards
bodies.
The design of this phone complies with the FCC guidelines and these international standards.
CAUTION
Use only the supplied and approved antenna. Use of unauthorized antennas or modifications could
impair call quality, damage the phone, void your warranty and/or result in violation of FCC
regulations.
Do not use the phone with a damaged antenna. If a damaged antenna comes into contact with skin,
a minor burn may result. Contact your local dealer for a replacement of antenna.
Body Worn Operation
This device was tested for typical body-worn operations with the back of the phone kept 1.5 cm
from the body. To comply with FCC RF exposure requirements, a minimum separation distance of
1.5 cm must be maintained between the user's body and the back of the phone, including the
antenna, whether extended or retracted. The use of belt-clips, holsters, and similar accessories
should not containing metallic components in its assembly. The use of accessories that do not satisfy
these requirements may not comply with FCC RF exposure requirements, and should be
avoided.
For Your Safety FCC Part 15 Class B Compliance
This device and its accessories comply with part 15 of FCC rules. Operation is subject to the
following two conditions: (1) This device and its accessories may not cause harmful interference,
and (2) this device and its accessories must accept any interference received, including interference
that may cause undesired operation.

Advertisement

Table of Contents
loading

Table of Contents