Brother NV800E Operation Manual page 95

Error messages
Not enough available memory to save the pattern.
9
Delete another pattern?
OK to recall and resume previous memory?
10
Pattern extends to the outside of embroidery frame.
11
Pattern extends to the outside of embroidery frame.
12
Add no additional characters.
Pattern extends to the outside of embroidery frame.
13 This function cannot be used at this time.
Preventive maintenance is recommended.
14
Selected pattern field extends to the outside of the
embroidery frame.
15
The bobbin thread is almost empty.
16
The bobbin winder safety device has activated. Is
17
the thread tangled?
The carriage of the embroidery unit will
18
move. Keep your hands etc. away from the
carriage.
The pockets are full. Delete a pattern.
19
The safety device has been activated. Is the
20
thread tangled? Is the needle bent?
The USB media was changed. Do not change the
21
USB media while it is being read.
There is a pattern included that cannot be saved to
22 USB media. Save the pattern in the machine's
memory.
This pattern cannot be used.
23
24 This USB media cannot be used.
25 USB media error
USB media is not loaded. Load USB media.
26
F**
27
Cause/solution
This message is displayed when the memory is full and the pattern cannot
be saved.
This message appears if the machine is turned off while embroidering, then
turned on again.
Press to return the machine to the condition (pattern position and
number of stitches) when it was turned off. Follow the procedure described
in "If the thread breaks during sewing" on page E-24 to align the needle
position and embroider the remainder of the pattern.
This message appears when the embroidery character pattern is edited, for
example, rotated, so that it no longer fits within the embroidery frame.
This message appears when the embroidery character pattern is edited by
adding a line feed so that it no longer fits within the embroidery frame.
This message appears when the embroidery character pattern is resized or
switched between written vertically/horizontally so that it is too large for the
embroidery frame.
This message is displayed when the machine needs to be maintained. (page
A-3)
This message appears when the selected embroidery pattern is larger than
the extra large embroidery frame. Reduce the pattern size, or select a
different pattern.
This message appears when the selected embroidery pattern is larger than
the embroidery frame selected when "Embroidery Frame Identification View"
is set to "ON".
This message is displayed when the bobbin thread is running out. Follow the
procedure described in "If the bobbin runs out of thread" on page E-23.
This message is displayed when the bobbin is being wound, and the motor
locks because the thread is tangled, etc.
This message appears before embroidery unit moves.
This message is displayed when the memory is full and a pattern must be
deleted.
This message is displayed when the motor locks due to tangled thread or for
other reasons related to thread delivery.
This message is displayed when you attempt to select a pattern after the
USB flash drive in which the pattern is saved has been changed.
Depending on the pattern, it may not be possible to save it to a USB flash
drive.
This message appears when you try to retrieve a pattern that cannot be used
with this machine.
This message is displayed when you try to use incompatible media.
This message is displayed when an error occurs with the USB flash drive.
This message is displayed when you try to recall or save a pattern while no
USB flash drive is loaded.
If error message "F**" appears in the LCD while the machine is being used,
the machine may be malfunctioning. Contact your authorized dealer or the
nearest Brother authorized service center.
Troubleshooting
A
Appendix A-11