Premix condensing system boiler for remote d.h.w. storage cylinder connection (72 pages)
Summary of Contents for Radiant R1K
Page 1
Use Manual for model R1K 25 RAIN Premix condensing system boiler only heating, suitable for outdoor installation R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...
1. USER SECTION 1. USER SECTION The operations described in this section are addressed to all those who will use the machine. The machine must be used and accessed only by qualified operators that fully read and understood the User section, paying particular attention to the warnings.
DANGER DO NOT obstruct the air vents of the location in which the gas device is installed to prevent the formation of toxic explosive mixes. R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...
SWEEP FUNCTION ACTIVATION (HOLD FOR 7 SECONDS) VALUE OF THE PARAMETERS ADJUSTMENT KEY / HOLD THE KEYS AT THE SAME TIME FOR 5 SECONDS TO ACTIVATE DISPLAY BACK LIGHT FOR 10 MINUTES DISPLAY R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...
MODULATING POWER LEVEL OF THE BOILER (fig.2) 11. ERROR DISPLAY THAT CAN BE RESET 12. OFF OPERATING MODE 13. ERROR DISPLAY THAT CAN NOT BE RESET 14. OPERATION IN HEATING MODE ENABLED R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...
THE REMOTE TANK TO THE BOILER (ONLY FOR HYBRID DOMESTIC SYSTEM WITH OPTIONAL SENSOR) POWER SUPPLIED BY THE HEATING PUMP IN KW/H (ONLY FOR HYBRID DOMESTIC SYSTEM) HEATING FLOW RATE DISPLAY EXPRESSED IN L/MIN (IF THERE IS A FLOWMETER). R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...
OFF MODE burner; this is indicated by displaying the symbol ‘ ’ blinking. In this mode the boiler no longer meets the heating and domestic hot water demands, the anti-freeze, R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...
› the boiler is not blocked. gas supply. › Or leave the boiler in OFF operating mode keeping active the electrical and gas supplies so that the anti-freeze function may activate. R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...
2 minutes system relief cycle. Throughout this function the display will fig. 1 show the code “F33”. The boiler can work normally only after completing the operation. fig. 2 R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...
CUT OFF THE POWER SUPPLY FROM THE MAIN SWITCH AND THEN RESTORE IT, AS SOON AS THE ERROR CODE DISAPPEARS, THE BOILER WILL RESTART AUTOMATICALLY. IF THE BLOCK PERSISTS CONTACT THE TECHNICAL SUPPORT CENTRE. R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...
Page 14
FROM THE DISPLAY, THE BOILER WILL START AUTOMATICALLY. SUPPLY VOLTAGE CONTACT THE TECHNICAL SUPPORT CENTRE. COMMUNICATION FAULT BETWEEN CONTACT THE TECHNICAL SUPPORT CENTRE. MODBUS CONTROLLER AND MODBUS CONTROL UNIT R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...
1.1.10. ACTIVE FUNCTIONS SIGNALLING CODES CODE FUNCTION INTERVENTION HEATING ANTI- WAIT UNTIL THE OPERATION FREEZE FUNCTION IS COMPLETED ACTIVE SYSTEM WAIT UNTIL THE OPERATION RELEASE CYCLE IN IS COMPLETED PROGRESS R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...
(Waste Electrical and Electronic Equipment) shows that this product can not be dismantled as domestic waste. Proper dismantle of this product helps preventing potentially negative consequences on human health and environment. R1K 25 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS...