Panasonic KX-FP362CX Service Manual page 22

KX-FP362CX
4.1.2.1. MAINTENANCE LIST
NO. OPERATION
1 Document Path
2 Rollers
3 Platen Roller
4 Thermal Head
5 Sensors
6 Glass
7 Abnormal, wear and tear
or loose parts
4.1.2.2. MAINTENANCE CYCLE
No. Item
1 Separation Roller (Ref. No. 141)
2 Separation Rubber (Ref. No. 11)
3 Feed Rollers (Ref. No. 9)
4 Thermal Head (Ref. No. 95)
5 Platen Roller (Ref. No. 54)
6 Pickup Roller (Ref. No. 46)
* These values are standard and may vary depending on usage conditions.
CHECK
Remove any foreign matter such as paper.
If the roller is dirty, clean it with a damp cloth then dry
thoroughly.
If the platen is dirty, clean it with a damp cloth then dry
thoroughly. Remove the paper and film cartridge before
cleaning.
If the thermal head is dirty, clean the printing surface with a
cloth moistened with denatured alcohol (alcohol without
water), then dry thoroughly.
Hook switch (SW101), Paper top sensor (PS501), Film
end (SW501), Cover open switch (SW502), Document top
switch (SW353), Document set switch (SW352). Confirm
the operation of the sensors.
If the glass is dirty, clean with a dry soft cloth.
Replace the part. Check if the screws are tight on all parts.
Cleaning Cycle
3 months
3 months
3 months
3 months
3 months
3 months
Refer to DOCUMENT FEEDER (P.27).
Refer to THERMAL HEAD (P.28).
See COMPONENT LOCATIONS (P.21) and
HOW TO REMOVE THE DIGITAL, ANALOG,
POWER SUPPLY, SENSOR BOARDS AND
AC INLET (P.40).
Refer to DOCUMENT FEEDER (P.27).
Cycle
7 years* (31,500 documents) Refer to HOW TO REMOVE THE MOTOR
7 years (31,500 documents)
7 years (31,500 documents)
7 years (31,500 documents)
7 years (31,500 documents)
7 years (31,500 documents)
22
REMARKS
—
—
—
Replacement
Procedure
BLOCK AND SEPARATION ROLLER
(P.41).
Refer to COMPONENT LOCATIONS (P.21).
Refer to DISASSEMBLY INSTRUCTIONS
(P.29).
Refer to HOW TO REMOVE THE
THERMAL HEAD (P.35).
Refer to HOW TO REMOVE THE PLATEN
ROLLER AND BACK COVER (P.36).
Refer to HOW TO REMOVE THE PICKUP
ROLLER (P.37).