Table of Contents
Advertisement
XF60-Q2901 Explosion-Protected Network Camera
About detectors
Note
By default, maximum temperature in the zone is used as the base for detection type Increase.
-
To edit emissivity settings in the zone: Select Advanced Settings and enter an emissivity value (0.50 – 1.00).
Different materials have different emissivity levels. See Material Emissivity Table on page 31.
5. For detection type Above (A) or Below (B): Enter the Detection Temperature in the zone.
D:
Actual temperature increase in the zone
E:
Temperature in the zone
F:
Your temperature increase rate, expressed in degrees (°C or °F) per seconds
G:
Measurement point that triggers or untriggers an alarm
29
Advertisement
Table of Contents
