Samsung RF28K9380SR User Manual page 53

NOTE
• A newly installed filter may cause the water dispenser to spurt water briefly. This is
because of air entering the waterline.
• This replacement process cause the refrigerator to drip water onto the floor. Simply
wipe up with dry cloths.
Reverse osmosis water filtration system
The water pressure of the water supply system to a reverse osmosis water filtration
system must be between 35 psi and 120 psi (241 kPa and 827 kPa).
The water pressure of the reverse osmosis water filtration system to the refrigerator's
cold water line must be at least 40 psi (276 kPa). If the water pressure is below the
specified:
• Check if the sediment filter in the reverse osmosis system is blocked. Replace the filter
if necessary.
• Refill the water tank in the reverse osmosis system with water.
• If your refrigerator has a water filter, it may further reduce the water pressure when
used in conjunction with a reverse osmosis system. Remove the water filter.
For more information or servicing, contact a licensed plumbing professional.
Ordering a new filter
To purchase a new water filter, contact a local Samsung service center.
LED Lamps
To replace the lamps of the refrigerator, contact a local Samsung service centre.
WARNING
The lamps are not user-serviceable. Do not attempt to replace a lamp yourself. This can
cause electric shock.
Untitled-8 53
5. Turn the cartridge knob clockwise to
lock into place.
6. Press and hold Cubed Ice on the feature
panel for 3 seconds to reset the filter.
The filter indicator (
7. When replacing is complete, open the
water valve and run water through the
dispenser for about 7 minutes. This is
to remove impurities and air from the
water line.
) turns off.
English 53
2016-09-29 7:54:29