Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for HIKOKI G 3612DA
Summary of Contents for HIKOKI G 3612DA
- Page 1 G 3612DA • G 3613DB G 3612DA G 3613DB Handling instructions...
- Page 2 G3612DA G3613DB &...
- Page 4 [G3612DA] 9500 min- 5500 min- 3000 min- [G3613DB] 2 3 4 5 A 15° – 30°...
- Page 6 c) Prevent unintentional starting. Ensure the GENERAL POWER TOOL SAFETY switch is in the off position before connecting to WARNINGS power source and/or battery pack, picking up or carrying the tool. WARNING Carrying power tools with your fi nger on the switch Read all safety warnings and all instructions.
- Page 7 b) Use power tools only with specifi cally g) Do not use a damaged accessory. Before each use designated battery packs. inspect the accessory such as abrasive wheels for Use of any other battery packs may create a risk of chips and cracks, backing pad for cracks, tear or injury and fi...
- Page 8 toward or away from the operator, depending on direction of ADDITIONAL SAFETY WARNINGS the wheel’s movement at the point of pinching. SPECIFIC FOR ABRASIVE CUTTING- Abrasive wheels may also break under these conditions. Kickback is the result of power tool misuse and/or incorrect OFF OPERATIONS operating procedures or conditions and can be avoided by taking proper precautions as given below.
- Page 9 – Check that the work piece is properly supported; 9. Keep the tool’s terminals (battery mount) free of swarf – Do not use cutting off wheel for side grinding; and dust. – Ensure that sparks resulting from use do not create ○...
- Page 10 ○ Make sure that any swarf and dust falling on the power REGARDING LITHIUM-ION BATTERY tool during work do not collect on the battery. TRANSPORTATION ○ Do not store an unused battery in a location exposed to swarf and dust. When transporting a lithium-ion battery, please observe the ○...
- Page 11 NAMES OF PARTS (Fig. 1 – Fig. 15) Warning Motor Charge indicator lamp Remaining battery indicator switch Battery level indicator Nameplate switch Battery Battery level indicator Lock pin & Lights ; lamp The battery remaining power is over 75% Side handle Lever Lights ;...
- Page 12 NOTE 2. Battery Due to HiKOKI’s continuing program of research and Model BSL36A18 development, the specifi cations herein are subject to change without prior notice. Voltage 36 V / 18 V (Automatic Switching*) Electronic control 2.5 Ah / 5.0 Ah ○...
- Page 13 (2) Regarding the temperatures and charging time of the rechargeable battery The temperatures and charging time will become as shown in Table 2. Table 2 Charger UC18YSL3 Type of battery Li-ion Temperatures at which the -10°C – 50°C battery can be recharged Charging voltage 14.4 Multi volt...
- Page 14 *1 WARNING MOUNTING AND OPERATION Before use, be sure to tighten the wheel nut with the included wrench. Failure to tighten could result in the wheel nut Action Figure Page loosening when the brake is activated during a stop. Removing and inserting the battery NOTE The wheel washer is specifi...
- Page 15 MAINTENANCE AND INSPECTION Important notice on the batteries for the HiKOKI cordless power tools 1. Inspecting the depressed center wheel Please always use one of our designated genuine Ensure that the depressed center wheel is free of cracks batteries. We cannot guarantee the safety and and surface defects.
- Page 16 TROUBLESHOOTING Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your dealer or the HiKOKI Authorized Service Center. 1. Power tool Symptom Possible cause Remedy Tool doesn’t run No remaining battery power Charge the battery.
- Page 17 Symptom Possible cause Remedy USB power lamp does not The USB power lamp lights up green to This is not a malfunction. switch off even though the indicate that USB charging is possible. USB device has fi nished charging. It is unclear what the The USB power lamp does not switch off...
- Page 18 G3612DA G3613DB (2XCP) (NNP) (2XCP) (NNP) (115 mm) (115 mm) (125 mm) (125 mm) – – (BSL36A18) (BSL36A18) – – – –...
- Page 19 938332Z 115 mm : 337229 125 mm : 337231 371677 336865 115 mm : 316821 (A36Q) 125 mm : 316822 (A36Q) 994324 115 mm : 332785 125 mm : 332788 UC18YSL3 BSL36A18 (14.4V – 18V) 375802 329897 336471...
- Page 21 English Dansk Română GUARANTEE CERTIFICATE GARANTIBEVIS CERTIFICAT DE GARANŢIE 1 Model No. 1 Modelnummer 1 Model nr. 2 Serial No. 2 Serienummer 2 Nr. de serie 3 Date of Purchase 3 Købsdato 3 Data cumpărării 4 Customer Name and Address 4 Kundes navn og adresse 4 Numele și adresa clientului 5 Dealer Name and Address...
- Page 23 Tel: +32 2 460 1720 URL: http://www.hikoki-powertools.hu Fax: +32 2 460 2542 URL http://www.hikoki-powertools.be Hikoki Power Tools Polska Sp. z o. o. ul. Gierdziejewskiego 1 Hikoki Power Tools Italia S.p.A 02-495 Warszawa, Poland Via Piave 35, 36077, Altavilla Vicentina (VI), Italy...
- Page 24 EN60745-2-3:2011+A2:2013+A11:2014+A12:2014+A13:2015 EN60335-1:2012+A11:2014 EN60335-2-29:2004+A2:2010 EN55014-1:2006+A1:2009+A2:2011 EN55014-2:1997+A1:2001+A2:2008 Representative offi ce in Europe 30. 8. 2019 Hikoki Power Tools Deutschland GmbH Naoto Yamashiro European Standard Manager Siemensring 34, 47877 Willich, Germany 30. 8. 2019 Head offi ce in Japan Koki Holdings Co., Ltd.
Need help?
Do you have a question about the G 3612DA and is the answer not in the manual?
Questions and answers