Approvals - Siemens SIMATIC NET 12M Operating Instructions Manual

Approvals

The SIMATIC NET products described in these Operating Instructions have the approvals listed
below.
Note
Issued approvals on the type plate of the device
The specified approvals apply only when the corresponding mark is printed on the product. You
can check which of the following approvals have been granted for your product by the markings
on the type plate.
Certificates for shipbuilding and national approvals
The device certificates for shipbuilding and special national approvals can be found on the pages
of Siemens Automation Customer Support under the following entry ID: 57337426
support.automation.siemens.com/WW/view/en/57337426).
Under this entry, go to the required product and select the following settings: "Entry list" tab >
entry type "Certificates".
Standards and test specifications
The device meets the following standards and test specifications. The test criteria for the module
are based on these standards and test specifications.
IEC 61131–2
The devices described in this manual fulfill the requirements and criteria of the IEC 61131-2
standard (Programmable controllers, Part 2: equipment requirements and tests).
EC declaration of conformity
The SIMATIC NET products described in these operating instructions meet the requirements and
safety objectives of the following EC directives and comply with the harmonized European
12M bus terminal
Operating Instructions, 06/2022, C79000-G8976-C333-02
5
(http://
25