Table of Contents
Advertisement
Available languages
Available languages
ASSEMBLY INSTRUCTIONS
8. Remove reflector panels (A) and reflector plate (B) from
packaging.
WARNING: Remove protective plastic cover before
assembling.
9. Slide two reflector panels (A) together.
Insert one screw M6 X 10 (II). Slide one washer Φ 6(HH)
over threaded end of screw M6 X 10 (II) and screw on
M6 cap nut (JJ) loosely. Attach the third panel on both
sides to the two already joined panels using two more
M6 x 10 screws (II), two more Φ6 washers (HH), and
two more M6 cap nuts (JJ). Note: For proper alignment
of reflector panels, keep bolts loose until all parts are
together and then tighten.
Hardware Used
Washer Φ 6
HH
JJ
M6 Cap nuts
10. Slide reflector plate (B) onto reflector panels (A).
Insert one screw M6 X 10 (II). Slide one washer Φ 6 (HH)
over threaded end of screw M6 X 10 (II) and screw on
M6 cap nut (JJ) loosely. Repeat procedure to complete
the assembly of all four sections. Fully tighten all of
the screws in the rolled edge.
Hardware Used
Washer Φ 6
HH
II
Screw M6 X 10
JJ
M6 Cap nuts
II
Screw M6 X 10
x 3
x 3
x 6
x 6
x 6
8
9
JJ
HH
II
x 3
10
JJ
HH
II
9
A
B
TT
B
A
A
Advertisement
Table of Contents
