LG 49UF852V Safety And Reference page 12

Make sure to use screws and wall mount bracket that meet the VESA
standard. Standard dimensions for the wall mount kits are described in
the following table.
Separate purchase (Wall mounting bracket)
43UF69**
Model 40/43UF77**
40/43UF80**
VESA (A x B) 200 x 200
Standard screw M6
Number of screws 4
LSW240B
Wall mount bracket
MSW240
60/65UF77**
60/65UF80**
60/65UF85**
Model
65UF86**
65UF95**
65UG87**
VESA (A x B) 300 x 300
Standard screw M6
Number of screws 4
Wall mount bracket LSW350B
B
CAUTION
Disconnect the power rst, and then move or install the TV.
Otherwise electric shock may occur.
Remove the stand before installing the TV on a wall mount by
performing the stand attachment in reverse.
If you install the TV on a ceiling or slanted wall, it may fall and
result in severe injury. Use an authorised LG wall mount and
contact the local dealer or quali ed personnel.
Do not over tighten the screws as this may cause damage to the TV
and void your warranty.
Use the screws and wall mounts that meet the VESA standard. Any
damages or injuries by misuse or using an improper accessory are
not covered by the warranty.
12
49UF69**
49/55UF77**
49/55UF80**
49/55UF85**
55UF86**
55UF95**
55UG87**
300 x 300
M6
4
LSW350B
MSW240
70UF77**
79UF86**
600 x 400
M8
4
LSW640B
A
NOTE
Use the screws that are listed on the VESA standard screw
speci cations.
The wall mount kit includes an installation manual and necessary
parts.
The wall mount bracket is not provided. You can obtain additional
accessories from your local dealer.
The length of screws may di er depending on the wall mount.
Make sure to use the proper length.
For more information, refer to the manual supplied with the wall
mount.
When installing the wall mounting bracket, use the adhesive
label provided. The adhesive label will protect the opening from
accumulating dust and dirt. (Only when the label is provided)
Provided item
Adhesive label
When attaching a wall mounting bracket to the TV, insert the wall
mount spacers into the TV wall mount holes to adjust the vertical
angle of the TV. (Only when the item of the following form is
provided)
Provided Item
Wall Mount Spacer
When removing the stand cover, insert a at tool as shown. (e.g., a
at screwdriver) (Only 79UF86**)
Flat tool