Operation - Makita DFS450 Instruction Manual

1mm (0.04")
1
008879
1mm (0.04")
1
008881
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the bit
To remove the bit, pull the locator. Then grasp the bit with
a pair of pliers and pull the bit out of the magnetic bit
holder. Sometimes, it helps to wiggle the bit with the
pliers as you pull.
1
008883
To install the bit, push it firmly into the magnetic bit holder.
Then install the locator by pushing it firmly back.
2
1
3
008891
1. Locator
1. Locator
1. Locator
1. Locator
2. Bit
3. Magnetic bit
holder
6
Bit storage
008890
Fit the bit into the protrusion at the tool.
Carry hook
The carry hook is convenient for temporarily hooking the
tool. It can be installed on either side of the tool.
When removing the carry hook, widen it by pressing its
right ends ON BOTH SIDES in the directions of arrow (1)
and raise it in the direction of the arrow (2).
1
2
1
1
014266

OPERATION

Screwdriving operation
014267
Fit the screw on the point of the bit and place the point of
the screw on the surface of the workpiece to be fastened.
Apply pressure to the tool and start it. Withdraw the tool as
soon as the clutch cuts in. Then release the switch trigger.
CAUTION:
When fitting the screw onto the point of the bit, be
•
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
rotate suddenly. This could damage a workpiece or
cause an injury.
Make sure that the bit is inserted straight in the screw
•
head, or the screw and/or bit may be damaged.
1. Hook