Monogram Advantium ZSA1202 Owner's Manual page 38

Questions?
Use this
problem
solver
38
Problem
DISPLAY
The display is blank.
"Control Panel
LOCKED" appears
in display.
Control display is
lighted yet oven
will not start.
OTHER PROBLEMS
The door and inside
of the oven feels hot.
Floor of the oven is
warm, even when
the oven has not
been used.
Oven will not start.
Glass microwave
tray does not lock
into center hub.
Troubleshooting
Possible Causes
The control has
been locked.
Clock is not set.
Door not securely closed.
START/PAUSE pad
not pressed after entering
cooking selection.
Delay Start was
accidentally set.
Oven is in DEMO Mode
CLEAR/OFF was pressed
accidentally.
The oven
produces intense heat
in a small space.
The cooktop light is
located below the oven
floor. When the light
is on, the heat it produces
may make the oven floor
get warm.
A fuse in your home
may be blown or the
circuit breaker tripped.
Power surge.
Plug not fully inserted
into wall outlet.
Advantium Oven
What To Do/Explanation
• This is normal. This display is intended
to turn off during standby.
• Press and hold CLEAR/OFF for about
3 seconds to unlock the control.
See Other Features Section.
• Follow prompts to set the clock.
• Open the door and close securely.
• Follow prompts
• Press CLEAR/OFF and reset.
• Unplug the oven for 1 minute, plug
the oven back into the wall DO NOT set
the oven clock, press and hold the HELP
and START/PAUSE pads for 3 seconds.
The control should exit DEMO mode.
Set clock and continue.
• Reset cooking program and press
START/PAUSE.
• This is normal.
• Use oven mitts to remove food when
when ready.
• This is normal.
• Replace fuse or reset circuit breaker.
• Unplug the oven, then plug it back in.
• Make sure the plug on the oven is
fully inserted into wall outlet.
• Align the protrusions on the bottom of
the glass microwave tray with the
indentation in the turntable. This fit is
not tight, some movement is normal
.