Channel Visibility Controls; Waveform Display Mode Control; Fig. 5.4.1. - Channel Visibility Controls; Fig. 5.5.1. - Waveform Display Mode Controls - ETC M520 Series User Manual

M520 series oscilloscope with rollmode
measurements with no time discontinuities and with time discontinuities caused by
ARM-ing.

5.4. Channel visibility controls

The channel visibility controls are located in the left of the main window.
"A" – activates/deactivates channel A waveform
"B" – activates/deactivates channel B waveform
The buttons on the bottom row are reserved for future use and have no effect.

5.5. Waveform display mode control

The controls are located in the bottom of the main window.
Fig. 5.5.1. – Waveform display mode controls
If more than 1 sample is displayed to one dot of the waveform, it is necessary
to set the mode of creating the dot. There are two buttons to choose the basic mode.
If "SNG" is selected, only the first sample of time period represented by the
dot is displayed.
If "Calc" is selected, the dot is calculated out of all samples. The method of
calculation depends on the following controls:
If the is activated, the displayed dot is calculated as average of the
measured samples.
If the is activated, the displayed dot is calculated as a maximum of
measured samples.
If the is activated, the displayed dot is calculated as a minimum of
measured samples.
If both the
minimum value of samples is displayed.
Fig. 5.4.1. – Channel visibility controls
and are activated, the line between maximum and
User's Guide
- 31 -