Demo Setup Window; Color Settings Window; Fig. 4.15.1.1. - Demo Setup Window - ETC M520 Series User Manual

M520 series oscilloscope with rollmode
File | Exit – Closes application.
Settings | Restore defaults – Reloads oscilloscope settings loaded on the
application start.
Settings | Load settings – Loads oscilloscope settings saved by selecting
"Settings | Save settings" menu item.
Settings | Save settings – Saves oscilloscope settings to hard disk (to other file
than default settings).
Settings | Demo setup – Opens window, where you can select signal
parameters in demonstration mode.
Settings | Color setup – Opens window for color selection.
Settings | Tool tip help – Activates/deactivates the tool tip help.
Settings | High priority - Sets high priority execution of oscilloscope
application.
Help | Index – Displays the Help index.
Help | ETC web – Starts the internet browser installed in the computer to
display the ETC's web site. This feature works only if the computer is already
connected to internet.
Help | Support – Sends the e-mail message to the ETC's customer support.
This feature works only if the computer has connection to internet.
Help | About – Displays information about product.

4.15.1. Demo setup window

The demo setup window is opened after click on the main menu item.
Channel A controls are located in left, channel B controls are located in the
right.
"Amplitude" – amplitude of demo signal in mV
"Period" – period of demo signal in ms
"Noise" – noise level in mV

4.15.2. Color settings window

The color settings window is opened after click on the main menu item.
Fig. 4.15.1.1. – Demo setup window
User's Guide
- 20 -