Table of Contents
Advertisement
Quick Links
Data Transmit Unit with Bi-directional Data Channel plus
The AMG4703E-SF is a standalone transmit unit designed to transmit and receive 1 data signal plus
full duplex 100BaseT Ethernet connectivity over one singlemode fibre.
The AMG4703E-SF is designed to be powered using an AMG2003 standalone power supply.
The AMG4703E-SF is designed to operate with an AMG4704E-SF or rackmount equivalent
AMG4704ER-SF data receive unit in a point to point configuration.
AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
Ethernet
Page 1 of 8
AMG4703E-SF
Instruction Manual
AMG4703E-SF Instruction Sheet
D18076-01.doc
Advertisement
Table of Contents
Related Manuals for AMG AMG4703E-SF
Summary of Contents for AMG AMG4703E-SF
- Page 1 Data Transmit Unit with Bi-directional Data Channel plus Ethernet The AMG4703E-SF is a standalone transmit unit designed to transmit and receive 1 data signal plus full duplex 100BaseT Ethernet connectivity over one singlemode fibre. The AMG4703E-SF is designed to be powered using an AMG2003 standalone power supply.
-
Page 2: Table Of Contents
Removal / replacement from / to the Case..................7 Safety Maintenance and Repair AMG Systems Ltd. reserves the right to make changes to this Page 2 of 8 AMG4703E-SF Instruction Sheet document without notice. The information herein is believed to D18076-01.doc... -
Page 3: Introduction
Ethernet Operation In order for the AMG system to transmit Ethernet signals, an onboard RJ45 Ethernet interface or X16003 Ethernet interface adaptor should be fitted to both the Transmit unit and the Receive unit. -
Page 4: Connections
RS485 – switch position – low (furthest from BNC connections) DATA CHANNEL B Data Channel B ........Not Present AMG Systems Ltd. reserves the right to make changes to this Page 4 of 8 AMG4703E-SF Instruction Sheet document without notice. The information herein is believed to D18076-01.doc... -
Page 5: Data And Audio Channel Configuration
RS485 bus high (+5 volts) and the other arm low (0 volts) using high value resistors within the third party equipment. In order to ensure that the AMG equipment detects a tri-state condition, then these resistors should have a value above 5kΩ. If the third party bias resistors are less the 750Ω... -
Page 6: Front Panel Indicators
OUT+ logic one (-V) present on OUT+ This represents the data signals being received on the optical fibre AMG Systems Ltd. reserves the right to make changes to this Page 6 of 8 AMG4703E-SF Instruction Sheet document without notice. -
Page 7: Physical Information
Weight ..........750grams Mounting Details The AMG unit is supplied with a clip-on mounting bracket which should be attached to a panel or wall using 2 off 4.0mm screws, see diagram on page 1 for dimensions. The unit is clipped into the mounting bracket, and is then held firmly in position. - Page 8 This page is intentionally blank. AMG Systems Ltd. reserves the right to make changes to this Page 8 of 8 AMG4703E-SF Instruction Sheet document without notice. The information herein is believed to D18076-01.doc be accurate. No responsibility is assumed by AMG for its use.
Need help?
Do you have a question about the AMG4703E-SF and is the answer not in the manual?
Questions and answers