HAMPTON BAY CH-7903-02 Use And Care Manual page 5

Installation (continued)
3
Removing the battery tab
□
Remove the back of the push button (C) by
pushing in the tab on the bottom with a small
screwdriver (not included).
□
Remove the orange battery tab from the push
button (C).
4
Testing the push button and
doorbell
□
Temporarily position the push button (C) where
it will be mounted.
□
Press the push button (C) to verify the
doorbell (A) and push button (C) work properly.
□
If the doorbell (A) does not sound, move the
doorbell (A) closer to the push button (C) and
test again.
NOTE: Do not permanently mount the sensor or push
button until the sensor, push button, and doorbell are all
working properly.
5
Testing the sensor and doorbell
In most cases, testing of the motion sensor (B) requires
two people; one person to activate the sensor (B) and
the other to listen for the doorbell (A) to sound.
□
On the bottom of the motion sensor (B), slide the
ON-TIME switch to the "TEST" position.
□
Temporarily position the sensor (B) near the
desired mounting location.
□
While someone is listening for the doorbell (A)
to sound, walk in front of the sensor (B). The
red LED on the sensor (B) should flash and the
doorbell (A) will sound "Beep-Beep". In the
"TEST" position, all motion must stop for 10
seconds before the sensor (B) will activate the
doorbell (A) again.
□
If the doorbell (A) does not sound, move the
doorbell (A) closer to the sensor (B) and test
again.
NOTE: Do not permanently mount the sensor or push
button until the sensor, push button, and doorbell are all
working properly.
C
MAX
SYNC
RANGE
MAX MIN
TEST 1 5
(MINS)
SYNC
ON-TIME
B
5
Please contact 1-844-760-3644 for further assistance.
RANGE
MIN
TEST 1 5
(MINS)
ON-TIME
B
HAMPTONBAY.com
C
A
A