Orbi Satellite Led Behavior - NETGEAR RBRE960B User Manual

information, see Sync your Orbi satellite with your Orbi router on page 16.
3. 2.5G Ethernet port: This Ethernet port provides a wired connection speed of up to
2.5 Gbps. You can use an Ethernet cable to connect this port to the 2.5G Ethernet
port on the router to create a wired backhaul connection. For more information, see
Set up and sync an Orbi satellite over a wired connection on page 17.
4. Gigabit Ethernet ports 1–3: You can connect a LAN device to each of the three
Gigabit Ethernet RJ-45 LAN ports.
5. Power connector: Connect the power adapter to this port.
6. Power LED: For more information about the Power LED behavior, see Orbi router
LED behavior on page 11.
7. Reset button: Use the Reset button to restart (reboot) the satellite or reset the
satellite to its factory default settings:
• Restart the satellite: Press the Reset button for less than five seconds. The Power
LED lights solid amber and the satellite restarts.
• Reset the satellite to its factory default settings: Press and hold the Reset
button until the Power LED starts blinking amber. The satellite resets and returns
to its factory settings. For information about the factory settings, see Factory
settings on page 146.

Orbi satellite LED behavior

The Orbi satellite has an LED on the front and a Power LED on the back.
The following table describes the LED behavior for the satellite's Power LED.
Table 3. Power LED behavior
LED color
Solid green
Solid amber
Blinking amber
Blinking red
Off
The following table describes the LED behavior for the satellite LED located on the front
of the satellite.
Overview
Orbi Quad-Band Mesh WiFi 6E System
Description
Power is on.
The satellite is restarting.
The satellite's firmware is resetting to its factory default settings.
The satellite's firmware is corrupted.
Power is not supplied to the satellite
13 User Manual