Gigabyte R281-2O0 Service Manual page 14

Storage
(R281-NO0)
Storage
(R281-N40)
SAS
Internal
Connectors
Front Panel
LED/Buttons
Rear Panel I/O
Backplane I/O
Hardware Installation
Front side: 24 x 2.5" U.2 hot-swappable HDD/SSD bays
Š
Rear side: 2 x 2.5" SATA/SAS hot-swappable HDD/SSD bays
Š
SAS card is required to enable SAS devices support
Š
Front side: 4 x 2.5" U.2, 20 x 2.5" SATA/SAS hot-swappable HDD/SSD bays
Š
Rear side: 2 x 2.5" SATA/SAS hot-swappable HDD/SSD bays
Š
LSI SAS35x36 expander
Š
Bandwidth: SATAIII 6Gb/s or SAS 12Gb/s per port
Š
Default configuration supports:
Š
4 x U.2, 0 x SAS/SATA drives
Š
SAS card is required to enable the drive bays
Š
Supported via add-on SAS Card
Š
2 x Power supply connectors
Š
4 x SlimSAS connectors
Š
2 x SATA 7-pin connectors
Š
2 x CPU fan headers
Š
1 x USB 3.0 header
Š
1 x TPM header
Š
1 x VROC connector
Š
1 x Front panel header
Š
1 x HDD back plane board header
Š
1 x PMBus connector
Š
1 x IPMB connector
Š
1 x Clear CMOS jumper
Š
1 x BIOS recovery jumper
Š
2 x USB 3.0
Š
1 x Power button with LED
Š
1 x ID button with LED
Š
1 x Reset button
Š
1 x NMI button
Š
1 x System status LED
Š
1 x HDD activity LED
Š
2 x LAN activity LEDs
Š
2 x USB 3.0
Š
1 x VGA
Š
1 x COM (RJ45 type)
Š
2 x RJ45
Š
1 x MLAN
Š
1 x ID button with LED
Š
2 x USB 3.0
Š
1 x VGA
Š
1 x COM (RJ45 type)
Š
2 x RJ45
Š
1 x MLAN
Š
1 x ID button with LED
Š
- 14 -