Yamaha RX-V990 Owner's Manual page 22

To record a source to tape (or dub from tape to tape)
1
Select the source to be recorded.
2
Play the source and press the corresponding input
selector, then turn the VOLUME control up to confirm
the input source. (For detailed information on the tuning
operations, refer to page 24.)
TAPE 2
MONITOR TAPE 1 TUNER
VIDEO AUX VCR 2 VCR 1
3
Set the tape deck or VCR to the recording mode.
4
To monitor a source selected by the REC OUT selector,
press the corresponding input selector button.
22
REC OUT
SOURCE
LD/TV TAPE 1
VCR 1 TUNER
VCR 2 CD
VIDEO AUX PHONO
VOLUME
l6
l8 l4
20
CD PHONO
24
28
34
LD/TV
40
50
60
70
–dB
1
Note:
• When the REC OUT selector is set to "SOURCE", the
source selected by the input selector buttons is output
through the TAPE 1-REC OUT, the TAPE 2-REC
OUT , the VCR 1-OUT, and the VCR 2-OUT
terminals.
• When the REC OUT selector is set to something other
than "SOURCE" and you press an input selector
button other than the one you pressed in step 2, the
recording source will not be changed and you can enjoy
another source while recording.
• To record from tape deck 2, set the REC OUT selector to
SOURCE, and press the TAPE 2/MONITOR input
l2
l0
selector.
8
6
• If the tape deck connected to the TAPE 2 REC OUT
4
3
2 terminal has 3-head monitoring capability, you can
l
0
monitor the signal just recorded on the tape by pressing
the TAPE 2/MONITOR switch.
• DSP, VOLUME, BASS, TREBLE and BALANCE
control settings have no effect on the material being
recorded.
• Signals connected to the 5CH DISCRT INPUT are not
output to the tape decks or video recorders.
To record the signals from an LD player, you must
connect the player to the LD/TV terminals.
2