Advanced Operation; Adjusting The Speaker Balance - Yamaha RP-U200 Operation Manual

ADVANCED OPERATION

Adjusting the speaker balance

This procedure lets you adjust the sound output level balance between the front, center and surround speakers by using the
built-in test tone generator. Make this adjustment so that each speaker output level is about the same when heard at the
listening position. This is important for high performance of the built-in DSP (Digital Sound field Processor), the Dolby Digital
decoder and the DTS decoder.
If this unit is set to the "Virtual 3D" mode (the surround speakers are not used) in the Application Software, you can adjust the
sound output levels of the speakers in the sound field of the "Virtual 3D" mode (including two virtual surround speakers).
Refer to "Setting adjustment on the Setup panel" on page 27. This setting cannot be made by using the front panel controls or
the remote control.)
* Use the remote control for adjusting the speaker output
levels at the listening position.
POWER
MEMORY
HALL
GAME
/ DTS
SURROUND
A
MUTE
1
Press the TEST key on the remote control.
TEST
* You will hear a test tone (so called pink noise) from each
speaker for about two seconds in the following order.
Front speaker (L) Center speaker
Surround speaker (L)
* The speaker currently outputting the test tone is shown
on the display.
PC
AUX1
AUX2
TUNER
PRESET MANUAL
JAZZ CHURCH
MOVIE LIVE
TEST ON/OFF
1, 5
B C
2, 3, 4
VOLUME
Remote control
Front speaker (R)
Surround speaker (R)
2
When the test tone is outputted from the left (L ch)
or right (R ch) front speaker:
Use the VOLUME keys on the remote control to
adjust the volume of each speaker.
In this step, adjust the volume balance between the left and
right front speakers.
(Adjustable range: –10 to 0)
VOLUME
3
When the test tone is outputted from the center
speaker (Cch):
Use the VOLUME keys on the remote control to
adjust the center speaker output level.
Make the sound output level of the center speaker about
the same as the left or right front speaker.
(Adjustable range: –20 to +10)
VOLUME
4
When the test tone is outputted from the left (Ls
ch) or right (Rs ch) surround speaker:
Use the VOLUME keys on the remote control to
adjust the volume of each speaker.
Make the sound output level of the surround speakers
about the same as the front speakers.
(Adjustable range: –20 to +10)
VOLUME
5
When the adjustments are finished, press the
TEST key.
TEST
The test tone stops.
ADVANCED OPERATION
Remote control
Remote control
Remote control
Remote control
19
E-