Yamaha PLG150-AP Owner's Manual page 8

Overview of the PLG150-AP
Plug-in Voice Data (for Modular Synthesis Plug-in System only)
This is Plug-in voice data, featuring a total of 64 voices that were created using the PLG150-AP Pre-
set voices (Board Voices). A Plug-in Voice is a Board Voice that has been processed using the param-
eters in the synthesizer or tone generator. If you transfer this data via bulk dump to a synthesizer or
tone generator, the Plug-in Voice is added to the User Voice Bank in the Plug-in Bank of the synthe-
sizer or tone generator.
The Plug-in Voice data in the CD-ROM are grouped into the following three folders.
Select the appropriate data in the folder corresponding to your particular synthesizer.
• "S80_CS6X" folder (for CS6x, CS6R, S30, S80)
• "S90MOTIF" folder (for S90, MOTIF, MOTIF-RACK)
• "MOTIF-ES" folder (for MOTIF ES)
How to Add to Plug-in Voice Data to a Synthesizer or Tone Generator
1
Connect a computer to your synthesizer or tone generator using a MIDI or
USB cable.
2
Start up the sequencer software.
3
If the PLG150-AP has been installed to the PLG1 slot, select the file
"**PLGV1.MID"; for slots PLG 2 and PLG 3, select files "**PLGV2.MID" and
"**PLGV3.MID," respectively. For details, see the owner's manual for the
sequencer software you are using.
4
The Plug-in Voice data is automatically transferred via bulk dump to the
synthesizer or tone generator.
5
When playback of the data reaches the end and the synthesizer or tone
generator can be operated normally, setup is complete.
• While the synthesizer or tone generator is receiving bulk data, do not turn off the device or sequencer, or dis-
NOTE
• The characters represented by "**" above differ depending on the folder.
• Before playing back the Plug-in Voice data, set the synthesizer or tone generator to allow reception of bulk data
8
PLG150-AP Owner's Manual
connect the cable.
(set the "RcvBulk" parameter to on).