Panasonic AJHD3700B-PE Operating Instructions Manual page 33

VIDEO OUT SD SET UP COMPOSITE menu
Key Key designation
F1 COMB FIL°
For controlling the comb
filter.
F2 B. CLIP
F3–F4 — —
F5 SYS SC
For adjusting the system
subcarrier.
F6 SYS H
For adjusting the system H
phase.
F7 INTERP.
Interpolation
F8 EXIT
F9 — —
F10 7.5%STUP
For adding 7.5% setup to
the composite output.
F11 LINE BLK
F12 STATE
F13 — —
° This item does not appear with the 1080/50i, 625/50i, 1080/25psf and 1080/25p system formats. (PAL output sig-
nals are not passed through the filter.)
Selects whether the analog composite output signals are to be
passed through the comb filter. However, when the F1 (COMB
FIL) key on the VIDEO OUT SD SET UP SDI menu has been set
to ON, the analog composite output will also be set to ON
regardless of which setting is selected for this menu item.
ON: The signals are passed through the filter and output.
OFF: The signals are not passed through the filter.
This is used to select whether signals below the SD output
pedestal level are to be clipped or not.
OFF: The signals are not clipped.
ON: The signals are clipped.
Adjusts the system subcarrier of the composite output.
(j180 to i180)
When this key is pressed together with the F key, the white-on-
black display (VAR MODE) is established, and the system
subcarrier can be adjusted using the ADJUST control.
Adjusts the system H phase of the composite output.
Adjusts the system H phase of the composite output.
When this key is pressed together with the F key, the white-on-
black display (VAR MODE) is established, and the system H
phase can be adjusted using the ADJUST control.
The system H phase is adjusted in sample increments. n0.5H
j858 to i858 (with 480/59.94i format)
j864 to i864 (with 576/50i format)
Initiates vertical interpolation during AT playback to reduce the
vertical movement of the playback images.
AUTO: Automatically initiates interpolation in the JOG or VAR
mode.
OFF: No interpolation.
Returns the VTR to the VIDEO OUT SD menu screen.
Selects whether to add 7.5% setup to the composite output.
(This setting takes effect with NTSC output signals only; This
setting is not displayed with PAL output signals.)
ON: 7.5% setup is added.
OFF: 7.5% setup is not added.
For transferring to the video output line blanking menu.
NTSC: Lines 10 to 21.
PAL: Lines 8 to 22.
Transfers the VTR to the VIDEO OUT SD SET UP CMPST
STATE menu screen.
– 33 –
Description