Setting The Position Of The Right And Left Channels* [Pan]; Adjusting Fine Pitch Offset Between Two Voices In Dual Mode [Detune]; Selecting The Reverb Type [Reverbtype]; Setting The Reverb Depth* [Reverbsend] - Yamaha P-250 Owner's Manual

Editing a Voice in Detail [VOICE EDIT]
• Refer to page 61 for general information on setting the parameters.
• Refer to pages 3—5 of the separate "Data List" for information on the default parame-
ter settings.
• All parameters accessed via the [VOICE EDIT] button are performance parameters (page 30).
Setting the position of the right and left
channels* [Pan]
TERMINOLOGY
Pan = Moving the sound from left to right, or right to left
You can specify the position in the stereo image from
which the sound is output.
In Dual mode:
Voice for editing (Main part or Layer part)
Press the D [–]/[+] buttons to set the pan position in the
range of L64 (hard left)— C (center) — R63 (hard right).
Adjusting fine pitch offset between two
voices in Dual mode [Detune]
TERMINOLOGY
Detune = Shifting the pitch of one sound relative to another
The pitch of the two voices selected in Dual mode can
be "skewed" slightly away from each other.
Press the D [–]/[+] buttons to set the skewing value (–20
— +20).
Positive (+) settings will raise the pitch of the first sound
and lower the pitch of the second sound.
Negative settings will lower the pitch of the first sound
and raise the pitch of the second sound.
66
P-250

Selecting the reverb type [ReverbType]

You cannot set this parameter for the voice parts "Left" and
"Left X Layer."
Press the D [–]/[+] button to select one of the following:
Room ............ Reverberation in a room
Hall1............. Reverberation in a concert hall
Hall2............. Reverberation in a hall slightly larger than
Hall1
Stage ..............Reverberation suitable for a solo instrument
Plate.............. Reverberation similar to vintage plate
reverb (created by suspending a steel
plate with springs)

Setting the reverb depth* [ReverbSend]

Press the D [–]/[+] buttons to set the value (0—127).
In Dual mode:
Voice for editing (Main part or Layer part)

Setting the chorus type [ChorusType]

You cannot set this parameter for the voice parts "Left" and
"Left X Layer."
Press the D [–]/[+] buttons to select one of the following:
Chorus .......... Adds a rich spread to the sound.
Celeste .......... Adds a swell and spread to the sound.
Flanger ........... Adds an ascending or descending jet sweep.
TIP
TIP