Advertisement
Open USB door "6" on controller and connect micro USB cable "5"
Charging
The headset will power off then enter charging mode - LED signal red while
charging
Solid white when full charge is reached
Using
headphones
Headphones
with Aneeda
voice
assistant
LED
Indication
l LED turned off when headset powered off or not charging
l Power on: white LED on 1s
l Power off: red LED on 1s
l Pairing: LED alternates flashing Red and White
l Connected: white LED 0.1s on/4s off
l Disconnected: white LED 0.1s on 2 times/2s off
l
l
l Active call: white LED 1s on /1s off
l Music play: white LED 1s on /4s off
l LED is changed from white blinking to Red blinking when battery low
l Charging： The headset will power off and enter charging mode - LED signal red
Music Mode
Function
Volume up
Volume
down
Play/Pause
Next song
Previous
song
1. Pair headphones to PULS or phone 1
2. Turn off the Bluetooth on PULS phone 1, and turn on Bluetooth on
phone 2
3. Search and pair the headset to phone 2
4. Turn on Bluetooth on PULS phone 1 and connect to headset
Use the Aneeda button on your PULS device to speak to and hear Aneeda on your
Incoming call: white LED 0.5s on /0.5s off
Outgoing call: white LED 0.5s on /0.5s off
while charging, Solid white when full charge is reached.
Status
Music or phone
call mode
Music or phone
call mode
Music mode
Music mode
Music mode
Sound
Operation
indication
No
Press volume +
No
Press volume -
No
Short press Function button
No
Double press Function button
No
-
Advertisement
