Motorola D401 Manual page 8

Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process for all the
handsets and chargers.
1. Plug the power adaptor with red connector into the socket marked
the charger and plug the other end into the mains power wall socket.
2. Remove the battery cover from the back of the handset and insert the 2 x AAA NiMH
rechargeable batteries supplied. Please note the '+' and '-' markings inside the battery
compartment and insert in the correct direction.
3. Slide the battery cover back into place.
4. If you are charging the batteries for the first time, place the handset on the charger to
charge for at least 24 hours continuously.
5. When the handset is fully charged,
display will show the time and handset number (e.g. 2) to indicate that it is registered
to the base.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA Ni-MH
550mA rechargeable batteries) supplied with your D4. Please do not use alkaline or
nonrechargeable batteries. It may cause permanent damage to the product and void the
warranty.
BATTERY LOW WARNING
If icon flashes on the display and you hear a warning beep every minute during a
call, you will need to recharge the handset before you can use it again.
When charging,
8
icon will scroll on the display. Once fully charged scrolling will stop.
icon will appear steady on the display. The
on the rear of
Getting started