Table of Contents
Advertisement
c
Pull up the holder to leave the blade in the
rubber area.
■ Installing
a
Grasp the shaft of the new blade, and then
insert it into the blade slot in the end of the
holder.
The blade shaft is held in place by a magnet in the
holder. Slowly insert the blade shaft, and then slowly
release it after the shaft snaps into place against the
magnet.
88
b
Twist on the holder cap to attach it to the
holder.
Fully tighten the cap until it can no longer be turned.
WARNING
• This is not a toy and is not intended to be used
by children. In order to prevent choking
hazards, do not allow infants/children to put the
protective cap in their mouths.
CAUTION
• After removing the blade holder from the
machine, be sure to attach the protective cap.
• Do not press the tip of the holder with your
hand or fingers because the tip of the blade will
extend and may result in injuries.
• Please remove protective cap from blade
holder before placing it into the machine
carriage.
• This is not a toy and is not intended to be used
by children. In order to prevent injury, do not
allow infants/children to touch the blade.
Advertisement
Table of Contents
