Rinse Aid; Setting Amount Of Rinse Aid; Switching Off Rinse Aid Refill Indicator - Bosch SPS59L12 Instruction Manual

Table of Contents

Advertisement

en

Rinse aid

Rinse aid
R i n s e
As soon as the rinse-aid refill
indicator H is lit on the fascia, there
is still a rinse-aid reserve of 1-2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l) only. If
the water hardness is over 21° dH,
rinse aid must be used.
1. Open the dispenser 1j by pressing
and lifting the plate on the cover.
2. Carefully pour rinse aid up
to the max. mark in the filler opening.
3. Close cover until it clicks shut.
4. To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.
12
a i d

Setting amount of rinse aid

The amount of rinse aid can be set from
:
to :
. Please set rinse aid on
:
to obtain very good drying results
( :
is already set in factory).
Do not change the amount of rinse aid
unless streaks (select lower setting)
or water stains (select higher setting)
are left on the utensils.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button h
until : ... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes
and the digital display )* displays
the factory setting :
5. Press programme button # until
the factory set value :
is indicated on the digital
display )*.
To change the setting:
1. Press programme button 3.
Each time the button is pressed,
the set value increases by one level;
when the value of :
reached, the display jumps back
to :
(off).
2. Press START button h.
The set value is saved.
Switching off rinse aid refill
indicator
If the rinse-aid refill indicator H is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
Proceed as described under "Setting
amount of rinse aid" and set the
value to :
The rinse aid refill indicator H is now
switched off.
.
has been
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sp series

Table of Contents