Picture Id Settings - LG 65SE3D Owner's Manual

30

PICTURE ID Settings

Only applies to certain models.
y
PICTURE ID is used to change the settings of a
specific set (display) using a single IR receiver for
multi-vision. Communication is possible between
a monitor with an IR receiver and other monitors
using RS-232C cables. Each monitor is identified
AUDIO
(RGB/DVI)
RS-232C OUT
by a Set ID. If you assign the PICTURE ID using
the remote control, only displays with matching
RS-232C IN
REMOTE
PICTURE ID and Set ID can be controlled remotely.
CONTROL IN
1
Assign the Set ID to the installed monitors as
.
shown below
IR & Light Sensor
RS-232C cables
2
Press the red ON button on the remote control
to assign the PICTURE ID.
3
Assign the Set ID to the selection of your
choice.
A set with a different Set ID from the PICTURE
y
ID cannot be controlled by IR signals.
RS-232C OUT RS-232C OUT
RS-232C IN RS-232C IN
PICTURE ID
NOTE
If PICTURE ID is set to 2, only the upper
y
right monitor, which has a Set ID of 2, can be
controlled by IR signals.
If you press the green OFF button for PICTURE
y
ID, the PICTURE IDs for all monitors are turned
off. If you then press any button on the remote
control, all monitors can be controlled by IR
signals regardless of Set ID.