Something Not Working; Troubleshooting - AEG KO-LAVAMAT 1271 Instruction Booklet

Something not working?

If, during the spin cycle, the machine makes an unusual
whistling noise, different from the noise made by tradi-
tional washing machines, this is due to a new type of
motor.
If water is not visible in the drum, this is due to
the modern technology of new washing
machines that use less water than traditional
machines.

Troubleshooting

If a problem arises, you can try to solve it yourself following the
instructions below.
If you call out an engineer when one of the following problems arises,
or to repair a fault due to incorrect use, the call-out will be charged
even if requested within the guarantee period.
During machine operation the following alarm codes may be displayed:
- E00: problem with the water supply
- E10: problem with water draining
- E20: door open
Once the problem has been eliminated, press the START/PAUSE
ton to restart the programme. If after all checks, the problem persists,
contact your local AEG Service Force Centre.
Problem
The machine does not work
Possible cause
The ON/OFF button
has not been depressed.
The main electrical fuse
has blown.
The door is not properly
closed (E20).
The plug is not connected. Insert the plug.
The START button has not
been pressed.
The DELAY START
option has been selected.
but-
Solution
Depress the button.
Replace the fuse.
Close the door; the click
of the lock should be heard.
Press the button.
Check the selected delay on
the display.
37