Display; Programme Progress Display - AEG KO-LAVAMAT 1271 Instruction Booklet

Display

The display shows the following information:
• if the programme selector dial is on the RESET O position, three flashing
dashes appear immediately after pressing the ON/OFF button to indicate
that the machine is ready to receive instructions for the required wash
programme;
• duration of the selected wash programme, calculated automatically
on the basis of the maximum recommended load for each type of fab-
ric.
• Selected drying time (max. 2 hours and 10 minutes for cotton, 1 hour
and 40 minutes for synthetics).
After the programme has started, the time remaining is updated every
10 minutes, and every 5 minutes during the last 20 minutes.
• When the programme has finished, three flashing zeros are dis-
played;
• delayed start, programmed using the special button
The selected delay (19 hours max.) is indicated in the display. The
countdown is updated every hour, and every 5 minutes during the last
hour.
• Heating phase. A dot to the right of the figures in the display indi-
cates that the machine is heating the water.
• Incorrect option selection. If an option which is not compatible with
the set wash programme is selected, the message Err is displayed.

Programme progress display

By selecting the wash programme, the pilot lights
corresponding to the various phases making up
the programme come on.
After the machine has started, only the running
phase pilot light stays on. When the programme
has finished, the END pilot light comes on.
Description of the appliance
.
Prewash
Wash
Rinse
Rinse hold
Pump out
Spin
Dry
End
15