Handset Display In Standby Mode (General Information Screen); Answering A Visitor's Call - hager SC900AX Manual

G

1.3 Handset display in standby mode (general information screen)

Handset battery status
Time
IMPORTANT: if the handsets or controllers are too close to each other when you perform different tests, this
may cause disturbance (Larsen effects, crackling, etc.). Move the various devices over 3 metres away from
each other.

2. Answering a visitor's call

The handset rings (1) (unless it is in silent
mode) and the backlighting flashes.
(1) If nobody answers, the handset rings for 20 secs (factory setting) and then stops. The duration of ringing can be
adjusted (see Programming handset operating options). If the handset is on its base, the handset rings at the
programmed volume (see Modifying handset operating options). If the handset is off its base, the ringing volume
becomes progressively louder (from level 1 to the programmed level).
(2) The names of access points can be customised (see Modifying doorphone operating options).
114
Gate, side gate and latch status
Outdoor temperature
The temperature displayed is
the temperature measured at
the last access point
programmed and is updated
every 10 minutes.
C
Indoor temperature
The temperature displayed is
the temperature measured on
the handset and is updated
every 10 minutes.
Garage status
Lighting status
The name of the access
point calling (2) is displayed.
C