Canon MG7560 Online Manual page 608

You can connect up to 5 devices using the access point mode.
Cannot Communicate with the Machine over the Wired LAN
Make sure that the machine is turned on.
Check1
Make sure that the LAN cable is connected properly.
Check2
Make sure that the machine is connected to the router with the LAN cable. If the LAN cable is loose, connect
the cable properly.
If the LAN cable is connected to the WAN side of the router, connect the cable to the LAN side of the router.
If the problem is not resolved, perform setup according to the instructions on our website.
Cannot Print, Scan, or Access the Card Slot from a Computer Connected to
the Network
Make sure that the network settings of the computer are correct.
Check1
For the procedures to set up the computer, refer to the instruction manual of your computer or contact its
manufacturer.
If the MP Drivers are not installed, install them.
Check2
Install the MP Drivers from our website.
When using wireless LAN, make sure that access control is not set to the
Check3
access point.
For the procedures to connect an access point and set it up, refer to the instruction manual of your access
point or contact its manufacturer.
Note
• To check the MAC address or the IP address of the computer, see
Address of the Computer.
Checking the IP Address or the MAC
608