Installation - AEG SCS51400S1 User Manual

6.2 Closing the door
Clean the door gaskets.
1.
2. If necessary, adjust the door. Refer
to "Installation".

7. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
SN
N
ST
T
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
7.2 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.
7.3 Door reversibility
The door of the appliance opens to the
right. To open the door to the left, do
these steps before you install the appli-
ance.
• Loosen and remove the upper pin.
• Remove the upper door.
• Remove the spacer.
ENGLISH
35