Table of Contents
Advertisement
INSTALLATION
Remove all packing material before using your
cooler.
wine
IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
This unit is designed for freestanding or built in installation but indoor use only. Position the unit in a dry and
well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in direct
sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below
41°F.
(The picture is just for reference)
For built-in installation, leave a 1/4" (6.35mm) space on each side and at the top of the wine
cooler to ensure proper air circulation to cool the compressor and condenser. Also, be sure to not obstruct
the front exhaust vent with any objects as this may affect the unit from performing properly.
For freestanding installation, leave 6" of space at the back, 10-12" of space on each side, and unlimited
clearance at the top of the beverage cooler are suggested to ensure proper air circulation to cool the
compressor and condenser. Do not place underneath a table, counter top, or anything of the sort as this will
not allow for proper air circulation.
Do not slide the unit into place.
Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To level the
wine cooler, adjust the front leveling legs at the bottom of the
cooler.
wine
For best performance it is recommended that you install the appliance in a location with an ambient
temperature between
41-100°F.
If the ambient temperature is above or below recommended temperatures,
the performance of the unit may be affected.
Plug the
cooler into an exclusive, properly installed-grounded wall outlet.
wine
10
Advertisement
Table of Contents
