Table of Contents
Advertisement
Using the timers
Record timer
4
1 Within 10 seconds
Push [SELECT, ENTER] up or down to set the
start time.
2 Within 10 seconds
Press [SELECT, ENTER].
5
Use the same steps to set the finish time
"TIMER REC SET" is displayed.
The start and finish times are displayed, then the
normal display is restored.
Note
≥If VAS is on, the recording may be shorter than the set time.
≥If you make recordings before the timer recording starts, be
careful that there is enough time remaining for the timer.
≥You cannot set the timer if there is less than one second of
recording time left.
≥"F REC" flashes while the record timer is functioning.
30
Set a time to start play.
Play stops when the file ends.
1To select
P u s h
up or
down
2To confirm
selection
Press
Play timer
Preparation
Set the clock ('page 7)
Select the file you want to play ('page 14)
1
Press [MODE].
You can now select a mode.
2
1 Within 10 seconds
Push [SELECT, ENTER] up or down so "TIMER
PLAY" flashes.
2 Within 10 seconds
Press [SELECT, ENTER].
The current setting is displayed for 2 seconds.
3
1 Within 10 seconds
Push [SELECT, ENTER] up or down so "TIMER
ON" flashes.
2 Within 10 seconds
Press [SELECT, ENTER].
The start time flashes.
4
1 Within 10 seconds
Push [SELECT, ENTER] up or
down to set the start time.
2 Within 10 seconds
Press [SELECT, ENTER].
"TIMER PLAY SET" is displayed.
The start time and file information are
displayed, then the normal display is
restored.
Note
"F PLAY" flashes while the play timer is
functioning.
PLAY
F
31
Advertisement
Table of Contents
