Whirlpool WGD7500GW Installation Instructions Manual page 22

6.
Remove screws from door
Remove screws at top, bottom, and side of door (4 screws).
Keep door screws separate from hinge screws as they are
different sizes.
7.
Separate inner from outer door
Holding door over towel on dryer, pry inner door and lift to
separate it from outer door.
NOTE: Do not pull on door seal or plastic door catches.
8.
Rotate outer door
Rotate outer door 180º and set it back down on inner door.
Be certain to keep cardboard spacer centered between
doors. Reattach outer door panel to inner door panel so
handle is on the side where hinges were just removed. Insert
4 door screws.
22
9.
Attach door hinges
Reattach door hinges to dryer door so that the larger hole is
at the bottom of the hinge.
10.
Remove door strike and door
strike label
Door strike
Remove door strike and door strike label from dryer cabinet.
Insert the door strike into hole where door strike label was
removed and secure with screw. Cover original door strike
hole with door strike label and press firmly into place.
Door strike label