Advertisement
Only run the soak program with partial loads.
The options cannot be used with the soak program.
The ENERSAVE option cannot be used with soak, ultraclean, or any programs which
do not include the final drying stage.
*
Standard program under EN 50242. If present, the ENERSAVE option must be
enabled.
**
See information sheet provided
***
IEC/DIN reference program. If present, the ENERSAVE option must be
enabled.
****
Reference program for laboratories. Detergent: 20 g in the dispenser + 10 g in
the door or tablet. Configuration: see photo in "using the baskets" section.
(1)
Program consumption and duration figures have been measured in accordance
with the EN 50242 standard. Values may vary depending on water supply and
ambient temperatures and the type and quantity of dishes loaded.
REFERENCES for the ENERGY LABEL supplied with the dishwasher:
-
Annual energy consumption is based on 280 standard wash cycles with cold
water and consumption of low-energy operating modes. Actual consumption
depends on the way in which the appliance is used.
-
Water consumption is based on 280 standard wash cycles. Actual
consumption depends on the way in which the appliance is used.
-
Information refers to the EN 50242 STANDARD program (identified in the
program table), which is the most effective in terms of combined energy and
water consumption. The program is recommended for dishes with a normal
level of dirt.
-
Drying efficiency class on a scale from "G" (minimum efficiency) to "A"
(maximum efficiency).
16
User instructions
NOTES AND REFERENCES
Advertisement
