Whirlpool WGD8000DW Installation Instructions Manual page 23

Remove the door assembly
1. Lay the door on a flat, covered surface with the inside of the
door facing up. Remove the 3 plugs with a plastic putty knife.
There is a cut out to stick the putty knife under to pop out.
2. Remove the 10 screws from the dryer door and set
screws off to the side.
3. Remove the inner door by using a plastic putty knife to
separate the sides and bottom of the dryer door and trim.
There are 2 snaps on left, right, and bottom of door. Insert
the putty knife next to the snaps.
4. When you have the door separated from the frame, use a
putty knife to lift up in the center tab and then pull door toward
you and out.
23