Table of Contents
Advertisement
Appendix
A. Troubleshooting
Status LED
After the power has been turned on, Network C amera will perform a self-diagnostic to
detect any hardware defects. The following table lists the LED patterns in general
conditions. In case of any fatal error, the LED will blink in another pattern.
C ondition
During self-diagnostic after power on
Ethernet signal is lost
Before network is setup
After network is setup
Any hardware failure
Reset and restore
Restore
the
defaults will lose any previous
settings. Reset or restore the
system after power on.
LED color
Blink in interchanged green and red
Steady red till Ethernet is detected
Steady green till IP address is confirmed
Blink green every second
Other patterns
There is a button hidden in the pinhole beside the
Ethernet socket. It is used to reset the system or
restore the factory default settings. Sometimes
resetting the system can make the system back to
normal state. If the system still has problems after
reset, restore the factory settings and install again.
RESET:
RESTORE:
factory
button continuously.
2. Wait for self-diagnostic to run twice.
3. Withdraw the wrench as soon as the second
self-diagnostic starts.
- 52 -
Poke the wrench to click on the button.
1. Poke the wrench to press on the
T: 886-2-22404099
F: 886-2-22404097
www.vivotek.com
Advertisement
Table of Contents
