Beam RST720 Installation Manual

Antenna RST715 / 720
MAGNETIC MOUNT ANTENNA: RST715
The magnetic mount antenna provides a versatile
solution that requires very little installation. The
cable supplied is the maximum specified length to
avoid any loss of signal and maintain call quality. It
is not recommended to extend this cable further to
avoid loss of dB beyond the specification.
The antenna should be attached to a metal surface
and placed in a position that provides the greatest
line of site to the sky, free of obstructions.
To install the antenna you will need to;
1. Use an existing mounting hole or drill a hole that will enable the antenna connector to pass through.
2. The hole size should not exceed the size of the hexagonal locking nut.
3. Remove the hexagon locking nut from the base of the antenna.
4. Feed the cable from the antenna through the hole until the antenna sits flush.
5. Feed the hexagonal nut through the cable and tighten on the antenna to hold it firmly in place.
6. Connect the cable to the communications device.
APPLICATIONS
VEHICLES
For more information on Iridium Antenna Guidelines visit our website at www.beamcommunications.com/antennainstallationguide
IN BUILDING
BOLT MOUNT ANTENNA: RST720
The bolt mount antenna is ideal for permanent
installations and enables the antenna system to
be securely affixed in location. The cable supplied
is the maximum specified length to avoid any
loss of signal and maintain call quality. It is not
recommended to extend this cable further to avoid
loss of dB beyond the specification.
RAIL TRUCK