Download Print this page
Beam Iridium RST740 Installation Manual

Beam Iridium RST740 Installation Manual

Iridium active antenna

Advertisement

Quick Links

Introduction
The RST740 antenna is designed for Iridium applications where
long RF cables are needed and a passive antenna cannot
be used. The RST740 has an integrated power amplifier (for
transmitting signals to the satellite) and low noise amplifier
(for receiving signals from the satellite) incorporated into the
antenna.
Iridium Active Antenna Kit Contents
1.
Antenna
2.
Bias box
3.
Mounting bracket
4.
3 x Set screws
5.
3 x Mounting screws
6.
3 x Flat washers
7.
3 x Split washers
8.
AC adapter
9.
DC power cable
Specifications
Equipment type
Integrated operating environment
Power supply requirement
RF Input power rating (US & Canada)
EIRP
Duty cycle
TX Operating frequency range
RX Operating frequency range
RF Input impedance
Modulation
Emission designation
Antenna type
Antenna connector type
Temperature rating
Storage:
Operational:
Compliance
Important Safety Information
WARNING
To satisfy FCC RF exposure requirements for mobile transmitting devices, the minimum safety distance is 55 cm (21.7 inches). This
separation distance should be maintained between antenna and people during operation of the antenna.
Changes or modifications not expressly approved by Beam Communications could void the users authority to operate the
equipment or the warranty.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
1
PHONE
ANT
2
WARNING
0.55 METRES
_
+
9-36 VDC
35.6 mm
(1.4 in)
3
4
5
6
7
35.6 mm
(1.4 in ID MAX)
8
9
Mobile or Fixed Base Station
[ x ] Commercial
[ x ] Light Industry & Heavy Industry
9 to 36V DC, 30W
29 dBm or 0.8 Watt peak (conducted)
12.31 dBW Max
N/A
1616.0 - 1626.5 MHz
1616.0 - 1626.5 MHz
50 Ohms
Q7W
96K1Q7W
Integral
TNC Female
-40°C to +80°C
-25°C to +55°C
FCC
Iridium Approved
Cable Length Requirements
To meet Iridium performance requirements and comply with FCC
regulations, care must be taken to use the appropriate total RF cable
length. Your antenna distributor should provide the appropriate cable.
BEAM Communications Pty Ltd
Iridium Active Antenna
RST740
Installation Manual

Advertisement

loading

Summary of Contents for Beam Iridium RST740

  • Page 1 To satisfy FCC RF exposure requirements for mobile transmitting devices, the minimum safety distance is 55 cm (21.7 inches). This separation distance should be maintained between antenna and people during operation of the antenna. Changes or modifications not expressly approved by Beam Communications could void the users authority to operate the equipment or the warranty.
  • Page 2 Outside/Above Deck 1. Bring the long RF cable to the top of Feed the cable though the Insert the Mounting Screws to Place the mounting bracket over the the pole or mast. mounting bracket and attach the fasten the mounting bracket to pole and tighten the set screws.