Handset Registration - Clarity XLC8 User Manual

HANDSET REGISTRATION

Registering the XLC HS
In order to use the XLC HS handset (sold separately), you must register it
to the base.
Pull the handset's battery tab located on the bottom of the device, and
then press MENU to start registering or deregistering your handset from
your system.
To register an unregistered handset
Press MENU to enter registration mode. You will see displayed on the
screen, "Handset Needs Registration."
Press and hold the FIND key on the
base visual ringer starts flashing. Release FIND key on the
Press MENU key on the handset.
The screen shows "Registering... ", then "Registration Successful"
(accompanied by five quick beeps).
Your handset is now registered to your
display "Handset X," (where "X" is the number of the actual handset
registered, such as the second or fourth handset, etc.).
TO REGISTER YOUR HANDSET AGAIN (or to register to a different
system)
1. In standby mode, press MENU.
2. Press UP or DOWN to advance the row reading "Phone Setup". Press
MENU to enter the setup section. The screen displays "Register" on the
screen's top row now.
3. Press MENU to enter the Registration section.
4. Press MENU again to select "Register."
5. Follow the Registration steps listed above.
To deregister the handset
1. See the five steps listed above, then press MENU to select "Deregister."
2. Your handset will deregister from your base as soon as you press MENU.
The screen will show "Handset X Deregistered"(again, where "X" is the
number of the handset registered), then "Handset Needs Registration."
base for five seconds, until the
system. Your screen will
base.