Summary of Contents for Campania International Palazzo Obelisk FT-29
Page 1
FT-29 Palazzo Obelisk Fountain Assembly Instructions Fountain Information: • Three people are recommended for the installation of this fountain! • This fountain holds approximately 30 gallons of water. • This fountain uses a extra-large fountain cover: FTNCOV-XLG • Compatible with #10 Refill Device and LED kits •...
Page 2
FT-29 Palazzo Obelisk Fountain Assembly Instructions Three people are recommended for the installation of this fountain! Fountain Set-Up: Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is installed properly, please read our instructions and tips before you begin.
Page 3
FT-29 Palazzo Obelisk Fountain Assembly Instructions Step 9 - Use another hose clamp to secure the 18" non-kink tubing to the pipe protruding from the bottom of the obelisk (FT-29A). Step 10 - Center the obelisk (FT-29A) over the column (FT-29B). FT-29A (175 lbs) 11"L x 11"W x 38"H Step 11 - Place the pump cover door (FT-29B/30CC) in the pump access opening of the pump...
Page 4
Maintenance: Pump Care - The fountain relies heavily on the quality of the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is fully submerged at all times to avoid damage. Step 2 - E nsure water level is sufficient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.