Advertisement
Quick Links
Fountain Components
Image
Item Description
Monteros
Fountain - Base
Monteros
Fountain - Large
Access Door
St. Remy
Fountain
Obelisk
St. Remy
Fountain -
Pump Cover
St. Remy
Fountain -
Pump Cover
Door
Beauport Urn
FT-293 Condotti Obelisk Fountain
Fountain Information:
• Three people are recommended for the installation of this fountain!
• This fountain holds approximately 25 gallons of water.
• This fountain uses a extra-large fountain cover: FTNCOV-XLG
• Compatible with #10 Refill Device and LED kits
• A special stopper is required to use the refill kit for this fountain
Pump Information:
OEMPF525 - 525 GPH Pump (16 ft. cord length)
Tools Required:
Bubble Level
Screwdriver
Component
Quantity
Item #
FT-269H
1
FT-269I
1
FT-281A
1
FT-281B
1
FT-281C
1
P-713
1
Assembly Instructions
Pump Kit Parts List
Image
Component
PK500 Pump
(use adapter indicated)
#10 Stopper
#7 Drain stopper
Approx. 12" length of 1/2" non-kink
Approx. 2" length of 5/8" clear vinyl
Approx. 2" piece of 1/2" CPVC pipe
Hose Clamps
Proudly
MADE IN USA
Quantity
1
1
1
1
tubing
1
tubing
1
Wedges
2
1
rev 4/24/2020
Advertisement
Related Manuals for Campania International Condotti Obelisk FT-293
Summary of Contents for Campania International Condotti Obelisk FT-293
- Page 1 FT-293 Condotti Obelisk Fountain Assembly Instructions Fountain Information: • Three people are recommended for the installation of this fountain! • This fountain holds approximately 25 gallons of water. • This fountain uses a extra-large fountain cover: FTNCOV-XLG • Compatible with #10 Refill Device and LED kits •...
- Page 2 FT-293 Condotti Obelisk Fountain Assembly Instructions Three people are recommended for the installation of this fountain! Fountain Set-Up: Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is installed properly, please read our instructions and tips before you begin.
- Page 3 FT-293 Condotti Obelisk Fountain Assembly Instructions Step 7 - Position the obelisk (FT-281A) over the pump house (FT-281B). Step 8 - Insert the CPVC pipe connected to the tubing assembly into the CPVC coupling protruding from the bottom of the obelisk (FT-281A). FT-281A (175 lbs) 10.5"L x 10.5"W x 37"H Step 9 - Fit the small pump house door (FT-281C) into the pump house (FT-281B).
- Page 4 Maintenance: Pump Care - The fountain relies heavily on the quality of the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is fully submerged at all times to avoid damage. Step 2 - E nsure water level is sufficient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.