Positioning Logs; Fireplace Screen; Decorative Volcanic Ash - Majestic fireplaces UVHK23MP Installation And Operating Instructions Manual

Positioning Logs

The logs must be positioned ONLY as illustrated in Figures 12,
13 and 14
•
Position the front log so that the large notch in the underside
of the right end of the log fits securely and rests on the sheet
metal control cover as shown in Figure 15. The front right
end of the log has a 'V' shaped notch to touch the back of the
right-hand grate bar as shown in Figure 16. The left under-
side of the front log has a tab that will fit into mating slot in the
ember base. When the log is properly placed, there should
be no gap between the right underside of the front log and
the top edge of the ember base.
CAUTION: Failure to position these parts as they are
described in these instructions will cause improper com-
bustion and may result in soot being produced.
•
Position the rear log so that the notches in the back of the
log go around and up against the vertical bars of the grate
assembly. Install the rear log behind the log spacer brackets.
The bracket in the center of the burner assembly must fit into
the hole in the center underside of the back log. (Refer to
Figure 17 for proper placement of the rear log.)
•
Position the top log so that its tongue fits securely into the slot
on the top of the rear log and the peg fits into the hole in the
top of the front log. The top log, when properly positioned,
establishes the correct spacing between the front and rear
logs.
Fig. 12 Split Bark logset position.
20008056
Split Bark Logset
WARNING: Failure to position the parts in accordance with
this diagram or failure to use only parts specifically ap-
proved with this heater, may result in property damage or
personal injury. Do not alter the logs!
•
The left and right twigs are to be placed into the appropriate
notches provided in the front and rear logs as shown. (Figs.
12, 13 and 14)
•
When using the Charred Oak log set the rear standoff must
be cut to allow the rear log to be positioned properly. (Fig.
17)
ENSURE THAT THE LOGS ARE CENTRAL AND VERTICAL
AS SEEN FROM THE SIDE. TO PREVENT UNWANTED
SOOTING, THE FLAME FROM THE BACK BURNER SHOULD
NOT TOUCH ANY LOG.
CAUTION: Proper location is critical. When positioning the log
set, make sure that the logs do not interfere with the sides of
the fireplace before securing the chassis.

Fireplace Screen

The fireplace screen must be in place when the appliance is
operating and unless other provisions for combustion air are
made, the screen must have openings for the introduction of
combustion air.

Decorative Volcanic Ash

The volcanic ash from the bag provided should be sprinkled
over the baseplate in front of and below the main burner. Do
not sprinkle this material on the fiber base, around the pilot or
on the main burner.
15