Picture Id - LG 47LV35A-5B.AFBZ Owner's Manual

44
CUSTOMIZING SETTINGS

Picture ID

Picture ID is used to change the settings of a
specific display using a single IR receiver for
multi-vision. The set receiving the IR signal
communicates with another set via an RS-232C
connection. Each set is identified by a Set ID. If
you assign the Picture ID using the remote control,
only displays with the same Picture ID and Set ID
can be controlled remotely.
IR Receiver
RS-232C
2X2 Multi-Vision
Set IDs are assigned as shown in the picture.
1
Press the red ON button on the remote control
to assign the Picture ID.
2
Picture ID
◄ Off ►
Close
To change the Picture ID, press the ON button,
or the left and right arrow buttons continuously.
Assign the ID you want.
Picture ID
Off
◀
Close
If you assign the Set ID to each set with
multi-vision, and then assign the Picture ID
using the red button on the remote control,
the key command is displayed for the set
with the same Set ID and Picture ID. A set
with different Set IDs and Picture IDs cannot
be controlled by IR signals.
NOTE
For example, if the Picture ID is assigned to
2, the upper right display (Set ID: 2) can be
controlled by IR signals.
For each set, you can change the settings
for the PICTURE, TIME, NETWORK and MY
MEDIA menus or the hot keys on the remote
control.
If you press the green OFF button for Picture
IDs, the Picture IDs for all sets are turned off.
If you then press any button on the remote
control, all sets will start working again.
Picture ID will be disabled while using the
MY MEDIA menu.
If Picture ID is set to Off, holding buttons
on the remote control will execute only one
action at a time.
▶