Table of Contents
Advertisement
Setting Shortcut Menus
Holding down a button displays a menu of functions and/or tones like the one shown below to appear. The content
of the menu depends on the button that is held down.
Button Name
Shortcut Menu Contents
CONCERT PLAY
Concert Play volume level setting
SONG
Song data settings
LAYER
Layer settings
REC
MIDI Recorder and Audio Recorder settings "Recording and Playback", page EN-32
METRONOME
Metronome settings
BERLIN GRAND
BERLIN GRAND tone demo songs
HAMBURG GRAND HAMBURG GRAND tone demo songs
VIENNA GRAND
VIENNA GRAND tone demo songs
Starting and Stopping
Playback
Use the procedure below with functions that allow
playback of data.
PREPARATION
• Select the song you want to play back.
– Concert Play: "To listen to a Concert Play Song
(Listen Mode)" (page EN-25)
– Music Library: "To play back a specific music
library song" (page EN-28)
– MIDI Recorder: "To play back from Digital Piano
memory" (page EN-36)
– SMF: "Playing Back Song Data Stored on a USB
Flash Drive" (page EN-29)
– Audio Recorder: "To play back data recorded on a
USB flash drive" (page EN-38)
1.
Press the /k button to start playback.
• Holding down the u arrow button during playback
fast reverses the track.
• Holding down the i arrow button during playback
fast forwards the track.
• Press and releasing the u arrow button causes
playback to jump to the beginning of the track.
2.
Press the /k button to pause playback.
• Press the /k button again to resume playback.
• You can use the procedure in the next section to
repeat play a specific section of a song.
Operations Common to All Modes
More Information
"To adjust the playback volume level of a Concert Play
song", page EN-27
"Song >Ent" in the "Parameter List", page EN-41
"Layering Two Tones", page EN-18
"To configure metronome settings", page EN-21
"Performing Demo Play", page EN-30
To repeat play a specific section of a song
• This procedure is not supported during demo song
play (page EN-30).
1.
While a tune is playing, press the ENTER
button at when the beginning of the section
you want to repeat (Point A) is reached.
• This causes "A" to flash on the display.
2.
Press the ENTER button again at when the
end of the section you want to repeat (Point
B) is reached.
• This causes "B" to flash on the display along with
"A".
• Repeat playback of the section from Point A to Point
B starts automatically.
• Holding down the u arrow button during repeat
playback jumps to Point A. Holding down the i
arrow button during playback jumps to Point B.
3.
To exit repeat playback, press the ENTER
button.
• This will cause "A" and "B" to stop flashing on the
display.
• In the case of music library, MIDI recorder, and SMF
songs, Point A and Point B can be specified in
measure units.
EN-9
Advertisement
Table of Contents
