Setting The Midi Channel; Connecting To An External Amplifier - Casio Piano Sound CPS-50 Operation Manual

Setting the MIDI channel 4 Mt Connecting to an external amplifier :
In order to communicate with other MIDI devices, the MIDI channel numbers of
both units must match. The MIDI channel can be set between channel | and channel
16. Follow the steps below to set the MIDI channel of the CPS-50. | ) IMPORTANT
¢ Before you connect the CPS-50 to any other device, be sure to first switch OFF
the power of the CPS-50 and the other device.
When turning the CPS-50's power ON or OFF after having made connections,
please set the volume controllers on both the CPS-50 and the other device to
"minimum". Also please be sure to read the owner's manuals of the equipment to
be connected. |
1. Switch the CPS-50 power OFF. | |
2. Hold down the PIANO 1 tone selector and turn the power back ON.. , ;
3. While still holding down the PIANO 1 tone selector, press the key on the |
keyboard which corresponds to the desired channel number. Channel numbers
are assigned to keyboard keys as shown below. ,
ae ett mete
If you connect the CPS-50's LINE OUT terminals to audio equipment or keyboard
amplifiers, you can enjoy playing at more impressive volumes. Note that the
| | connecting cord you use depends on the type of jack you are connecting to.
<<Connection ExaDIee = | _ Aras hiereaneul
| jacks (usually
, labeled "AUX IN")
'e — 1 § 19 18 20
'CPS-50 (Rear panel) | . : AUX IN
LINE OU
Notes
¢ Once you select a channel by pressing a keyboard key, the MIDI channel setting
mode is cancelled automatically. |
e The MIDI channel is automatically set to "1" when the power is turned ON.
¢ Tocancel the Auto Power OFF function in the MIDI mode, use the E.PIANO tone
selector instead of the PIANO | tone selector in procedure 2.
¢ The same MIDI channel is applied to both transmission and reception of MIDI
data.
1/4-inch (6.3mm) plug Pin plug
20 71
Tyree treet rae rr ei ra gS A rs Pr? a ly i, naa PPS nh -Pt Tre rer nn FORA a A I ST IO Se A ee ah 8 cet teem Ft