Remote Control - Sharp HT-SB31D Operation Manual

Sound bar home theater system
Table of Contents

Advertisement

Remote control

DO NOT INGEST BATTERY,
CHEMICAL BURN HAZARD
The remote control supplied with this prod-
uct contains a coin/button cell battery. If
the coin/button cell battery is swallowed, it
can cause severe internal burns in just two
(2) hours and can lead to death.
Keep new and used batteries away from
children. If the battery compartment does
not close securely, stop using the product
and keep it away from children.
If you think batteries might have been
swallowed or placed inside any part of the
body, seek immediate medical attention.
This product contains a CR Coin Lithium
Battery which contains Perchlorate Material
– special handling may apply.
California residents, see
www.dtsc.ca.gov/hazardouswaste/perchlorate/
■ Battery installation
1
While pushing the locking tab to-
wards the center of the remote con-
trol, slide out the battery holder.
Locking
2
Remove the old battery from the
battery holder, insert the new bat-
tery and then slide the battery hold-
er back into the remote control.
Battery holder
Polarity (+)
symbol
Battery type
Locking tab
WARNING
Back of
remote control
tab
Positive (+)
side up
Precautions for battery use:
Remove the battery if the sound bar will not be
used for a long period of time. This will prevent
potential damage due to battery leakage.
Caution:
Do not use rechargeable battery (nickel-
cadmium battery, etc.).
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type.
Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such
as sunshine, fire or the like.
Installing the battery incorrectly may cause
the sound bar to malfunction.
Notes concerning use:
Replace the battery if the operating distance
is reduced or if the operation becomes er-
ratic. Purchase "CR 2025", coin lithium
battery.
Periodically clean the transmitter on the re-
mote control and the sensor on the sound
bar with a soft cloth.
Exposing the sensor on the sound bar to
strong light may interfere with operation.
Change the lighting or the direction of the
sound bar if this occurs.
Keep the remote control away from mois-
ture, heat, shock, and vibrations.
■ Test of the remote control
The remote control can be used within the range
shown below:
Remote sensor
8" - 20'
(0.2 m - 6 m)
E-13
ON/
MUTE
STAND-BY
SOUND MODE
CINEMA
MUSIC
NEWS
BYPASS
SURROUND
INPUT

Advertisement

Table of Contents
loading

Table of Contents